VeEX UX400, User Manual

Page: 82 / 209

Copying Services
Tap on the
Copy
button on the bottom of the
Header
or
Service Attributes
tabs to copy frame
parameters specific to that tab to other services. For example, pressing Copy on the Header tab will
only transfer header parameters to other services.
Go back to top Go back to TOC
6.4.2 Results
Note : To run the test, make sure that traffic is being looped back at the far-end of the network under test.
6.4.2.1 Configuration Tests
Results - Config. Tests - Service 1
The
Config. Tests
tab lists the Pass/Fail status of each service and test.
Tapping on the table brings up a screen with
CIR
,
CIR/EIR
and
Policing Test
results for the chosen Service.
CIR
,
CIR/EIR Test
, and
Policing
tabs display min, mean,
and max values for
IR Mbps
,
FTD
,
FDV
,
Frame Loss Count
, and
Frame Loss Ratio (%).
If Step Load was selected for the CIR Test, these values will be displayed for
each step. If any measured values do not meet the service test parameters set in the Bandwidth and Threshold tabs, the test fails.
IR Mbps:
Information Rate. Measures the average Ethernet frame rate starting at the MAC address field and ending at the CRC.
FTD:
Measures the time that the frames can take to travel from source to destination.
FDV:
Measures the frame jitter.
Frame Loss Count:
Counts the number of lost frames.
Frame Loss Ratio:
Ratio of lost frames to the total transmitted frames.
CIR Test
: The test passes if all measured values are below the thresholds configured. If a threshold is disabled, it will not be evaluated towards pass/fail criteria.
CIR Test - Service 1
UX400 10G e-Manual D07-00-058P RevA00 Page 82 of 209