VeEX RXT3900, User Manual

Page: 43 / 383

measurement timer has to be set to a determined period. The table below describes the anomalies evaluated for the performance
analysis selected.
Go back to top Go back to TOC
6.6.3 General
The General setup page configures the audible alarm and APS protocol settings. Audible alarms may not be supported by all test
sets, technologies and applications.
General tab
APS Protocol:
Linear or Ring architectures are selectable. This determines how the APS bytes (K1/K2) are decoded in
the SDH Overhead Analyzer or how they are generated in the SDH Overhead Generator. It also determines how the APS
measurement will be made.
SDH/SONET:
SDH or SONET modes are available options. Defines the reference standard to be used for GUI
terminology and functionality. Select SDH for SDH and PDH applications. Select SONET for North American SONET and
DSn (T1 and T3). This may also change the behavior of certain menus and function.
STS-1 Bulk data
(SONET only): The STS-1 bulk mode fills the entire payload, except for the POH.
Result on start:
On or Off. Provides an automatic move to Result screen when it starts.
Auto Save:
Tap Auto Save and set it to
ON
to automatically save the results file.
Measurement Clock Source:
Internal Clock or Tx Clock Source; the measurement is synchronized to the Transmitted
(Tx) Clock.
Go back to top Go back to TOC
6.6.4 Auto-Config
The Auto-Configuration function is described below.
Auto-config tab
RXT-3900 e-Manual D07-00-111P Rev A00