VeEX RXT3900, User Manual

Page: 41 / 383

6.6 Measurement Configuration
Tapping the
Measurements
tab opens the setup screen for the Timer, Performance Analysis, and General configurations.
Measurements tab
Go back to top Go back to TOC
6.6.1 Timer Setup
Configure a test to run for a fixed duration and/or a delayed start.
Mode
: Manual, Timed, and Auto selections are available.
Manual:
This is directly linked to the Start/Stop function on the drop-down menu. The test starts as soon as the
Start
button is pressed.
Timed:
The test duration can be set by the user in seconds, minutes, hours or days. The test is activated by the
Start/Stop function on the drop-down menu and stops automatically when the defined time has elapsed.
Auto:
A predetermined start time can be set by the user. The test duration can be set in seconds, minutes, hours or days.
After programming the start time and duration, press the
Start
button and the test will be activated automatically when the
programmed start time is reached.
Note: M.2100 and M.2101 performance objectives are only available in Timed and Auto Mode.
Go back to top Go back to TOC
6.6.2 Performance Analysis
The Analysis setup page selects the type of ITU-T performance evaluation that will be performed by the unit. Depending on Test
mode, the selections include None, G.821, G.826, G.828, G.829, G.8201, M.2100, and M.2101. The available options may vary
depending on configuration.
Analysis
RXT-3900 e-Manual D07-00-111P Rev A00