Chapter 2 - Configuring the IP Address
2 - 4
MPA Installation Guide
Document No. CO 402227
5.
Close all open remote software connections to the MPA system, such as Remote GUI,
VNC, and/or SCPI.
6.
Connect the USB flash drive to the appropriate USB port
(the USB ports include
standard USB 2.0, USB 2.0 Micro-B (using a USB Micro-B adaptor cable), or USB 3.0)
.
7.
Typically, within less than 30 seconds the file on the flash drive will automatically
reconfigure the IP Address and Reboot the MPA system.
8.
The SCM-210’s green READY LED will turn Off, indicating that the system is rebooting.
Note
: If after 30 to 45 seconds the system does not reboot, this could indicate:
a.
The IP Address settings configured on the USB flash drive are the same as those
already programmed on the MPA system
b.
The mpa_ipconfig file was possibly renamed, or given a file extension.
c.
The mpa_ipconfig file was possibly saved to a sub-folder on the USB flash drive,
and not to the root directory.
d.
If the USB flash drive was not recognized the first time was inserted, then it may
be nesseccary to unplug the USB flash drive and plug it back in again.
9.
Disconnect the USB flash drive at this time.
10.
Wait for 4 to 5 minutes for the MPA system to completely reboot, and verify that the new
IP Address is displayed on the OLED screen
11.
The MPA is fully booted and operational again when the green READY LED illuminates.
