Troubleshooting
Boot-Up Errors
13
BOOT-UP ERROR 2
Table 4. Incorrect Boot-Up Sequence - Boot Sequence Stalled
Boot-Up Sequence
Visual Sequence
Symptom
Probable Cause
Action
1. Console Powered On at
the breaker.
2. Beeper sounds two
quick beeps, the Green
LED is flashing rapidly.
The Green LED
keeps flashing, but
the boot-up
sequence is stuck in
this step.
The console can
-
not read the SD
Card, is not able
to read the RAM,
or the SD Card is
missing.
1. Remove the console’s cover
and the Display/CPU assem
-
bly following the assembly
removal steps beginning on
2. Confirm SD is present, if not
order SD card. If present con
-
tinue to next step.
3. Remove the SD Card (Item 2
in Figure 3) by pushing in on
the SD Card then quickly
releasing it letting it spring
free of its enclosure’s latch so
you can slide it out. While you
have the SD Card out, check
the position of the write pro
-
tect slide on the side of the
SD Card, making sure it is in
the position shown below and
then reinsert it in its enclo
-
sure until it clicks into the
enclosure’s latch.
4. Reapply power to console. If
problem does not go away,
replace the SD card.
5. If problem still exists after
replacing the SD card, replace
the Display/CPU assembly.
<1
<1
