Component Removal Procedures
Replacing The Features iButton
27
Figure 6. Inserting SD Card In Its CPU board Enclosure
Replacing The Features iButton
This section only applicable for older consoles which have an iButton
1. Remove the Display/CPU Assembly as discussed on page 26.
2. Place the Display/CPU Assembly on a clean surface, display side down.
3. Locate the Features iButton (Item 1 in Figure 7).
4. Slide the iButton out from under the retaining clip until it is free of the holder.
5. With the flanged end up, slide the replacement iButton under the retaining clip until it snaps securely into the
holder.
Figure 7. Locating iButton on Older Console CPU Boards
LEGEND FOR NUMBERED BOXES IN Figure 4
1. Check the SD Card read/write slide position.
2. Insert the SD card into its enclosure with the contact side facing
the CPU board.
LEGEND FOR NUMBERED BOXES IN Figure 7
1. iButton
1
2
J40
1
