6
Printing Out Reports
With the TLS-50 Console Serial Package option you can print the reports described in this section on any printer
that has a 9-pin dot matrix print head, a serial interface, and is capable of emulating Epson print commands. The
report formats will fit on either letter size or A4 size paper.
You press the Print key to print a report. However, what report you print depends on what is visible in the LCD
display.
PRINTED REPORT FORMATS
The TLS-50 Console must have the Serial Package option and have the following Communications Setup
selections enabled:
• Baud rate set to 9600 (recommended) - However, if you experience problems printing at 9600 baud, lower the
baud rate to 2400),
• Parity set to None (recommended),
• Data length set to 8 (required),
• Stop bit set to 1 (recommended), and
• Handshake set to XON/XOFF (may be required at the higher baud rates).
Note, for printing to occur, the TLS-50 and printer communications settings must match.
Inventory Report Example
TANK
VOLUME
TC VOLUME
HEIGHT
WATER
TEMP
1
8284
8191
73.4
1.5
79.6
2
8813
-
79.1
3.2
-
3
11983
-
90.4
-
-
Notes:
3.
If the system setup parameter PRINT TC VOL is set to No, the TC VOLUME and TEMP columns will not print.
4.
If none of the connected probes have temperature measurement capability, the TC VOLUME and TEMP
columns will not print. However, if any probes in the system have temperature measurement capability, the TC
Volume and TEMP columns will print for those probes, but not for the others.
5.
If none of the connected probes have water measurement capability, the WATER column will not print.
However, if any probes in the system have water measurement capability, the WATER column will print for
those probes, but not for the others.
