Display Replacement Procedure
Before You Begin
4
2.
Notice the two small slots in the top of the display/keyboard door.
3.
Facing the inside of the display door, insert a flat blade screwdriver between the top of the plastic display/
keyboard cover and next to one of the two tabs of the cover that seat in the door’s slots (see Figure 2). Gently
pry down with the screwdriver blade near the tab to free it from the slot in the door, then repeat this procedure
to free the second tab. Firmly rotate the cover away from the door to free its bottom tabs from the bottom door
slots. Feed the two cables between the door(s) and remove the cover from the console and set it aside.
Figure 2. Top Display/Keyboard Cover Securing Tabs
4.
Get the new display/cover assembly from kit. Get the two blank wiring input labels from the kit, P/N 330636-
000 for a TLS-300 or EMC console, or P/N 330617-000 for a TLS-350 Series, EMC, ProMax or ProPlus
console.
5.
Remove the backing from the Power Area input label and press it into the left partition (1)on the back of the
cover. Remove the backing from the Intrinsically-Safe Area input label and press it into the right partition (2) on
the back of the cover (see Figure 3).
Figure 3. Display/Keyboard Cover Wiring Input Label Positions (330636-000 Labels Shown)
6.
With the old and new display/keyboard covers side by side, copy the wiring input notations from the old
display/keyboard cover labels onto the new cover’s wiring input labels.
Be especially careful to accurately
copy the wiring input notations from the old display/keyboard cover to the replacement cover!
1
2
