6
VEEDER-ROOT
PGM
RST
OP1
OP2
VEEDER-ROOT
PGM
RST
OP1
OP2
VEEDER-ROOT
PGM
RST
OP1
OP2
VEEDER-ROOT
PGM
RST
OP1
OP2
P R O G R A M M I N G
PROGRAM MODE
ENTERING PROGRAM MODE AND BASIC OPERATION
PARAMETER SEQUENCE
PGM
PGM
PGM
for 3 seconds
The name of the first parameter will appear
on the primary display.*
Pressing the Scroll Key or no key activity for
3 seconds will display the value for that
parameter. The secondary display will
indicate the one digit identifier for the
parameter. The digit in the secondary
display will flash to indicate the unit is in
Program Mode. If the Scroll Key was
pressed (instead of waiting 3 seconds), the
unit is in Edit Operation, as indicated by the
MSD flashing. If there had been no key
activity for 3 seconds, press the scroll key to
enter Edit Operation (MSD flashing). Use
the scroll and edit buttons to change the
value as in Operation Mode, described on
page 5. Press the Program Key to enter any
changes.
Successive presses of the Program Key will
scroll the display through the remaining
parameters in the Program Mode. To exit
Program Mode, hold the Program Key for 3
seconds.
The Program Mode can be accessed from the
Operation Mode by holding the Program Key
for 3 seconds.
* Parameter names will not appear on the
main display if the "Help" function has been
disabled in Program Mode.
C A L
C
Calibration Factor
Function: Used to scale the input into engineering units by multiplying this value by the number of pulses
received
Adjustment Range: 0.0001 to 9.9999
Default Value: 1.0000
d E c
PGM
P
d
Decimal Position
Function: Set the decimal point position for the displays
Adjustment Range: 0 to 0.0000
Default Value: 0
PGM
23456
CAL
C
1.0000
dEc P
Edit Operation
no key activity
for 3 secs. or
