Veeco Dektak 150, User Manual

Page: 120 / 349

Multiple Scan Operation 5-15
Use the Type tab to determine if you want display the data in raw form, with roughness included,
and/or with waviness included.
NOTE –
You cannot select the roughness data type unless you first activate the short pass
filter on the Filter Cutoffs tab of the Data Processing Parameters dialog box (see
Figure
5-25
). Likewise, you cannot select the waviness data type unless you activate the long pass
filter in that same dialog box. For more information, see the section that follows.
Data Processing Settings
Select one of the entries in the Data Processing section of the Scan Routines window to open the
corresponding tab of the Data Processing Parameters dialog box.
When you enter your data processing filtering settings as a scan parameter, the system automatically
performs data processing filtering during a scan. You can change these data processing filtering
parameters at the end of a scan.
NOTE –
In the Analytical Results display in the Data Plot window (see
Figure 5-24
),
analyzed raw data is denoted by an asterisk. Analytical results of filtered data have no
asterisk.
Figure 5-24: Analytical Results Display Showing Filtered Data
Click Filter Cutoffs to open the Filter Cutoffs tab of the Data Processing dialog box (see Figure 5-
25 ).