VEDETTE VFD300SEW, Manual

Page: 46 / 56

Troubleshooting
Caution! Before troubleshooting, disconnect the power supply.
Only a qualified electrician of competent person must do the
troubleshooting that is not in this manual.
Important! There are some sounds during normal use (compressor,
refrigerant circulation).
Problem Possible cause Solution
Appliance dose not
work
Mains plug is not plugged in or
is looses
Insert mains plug.
Fuse has blown or is defective Check fuse, replace if necessary.
Socket is defective
Mains malfunctions are to be
corrected by an electrician.
Appliance freezes
or cools too much
Temperature is set too cold or
the appliance runs at SUPER
modes.
Turn the temperature regulator to a
warmer setting temporarily.
The food is not
frozen enough.
Temperature is not properly
adjusted.
please look in the initial
Temperature Setting section.
Door was open for an extended
period.
Open the door only as long as
necessary.
A large quantity of warm food
was placed in the appliance
within the last 24 hours.
Turn the temperature regulation to
a colder setting temporarily.
The appliance is near a heat
source.
Please look in the installation
location section.
Heavy build-up of
frost on the door
seal.
Unusual noises
Door seal is not air tight.
Carefully warm the leaking sections
of the door seal with a hair dryer (on
a cool setting). At the same time
shape the warmed door seal by
hand such that it sits correctly.
Appliance is not level. Re-adjust the feet.
The appliance is touching the
wall or other objects.
Move the appliance slightly.
A component, e.g. a pipe, on
the rear of the appliance is
touching another part of the
appliance or the wall.
If necessary, carefully bend the
component out of the way.
Side panels are hot It’s normal. Heat exchange is in
the side panels
Take gloves to touch side panels if
need!
If the malfunction shows again, contact the Service Center.
These data are necessary to help you quickly and correctly. Write the
necessary data here, refer to the rating plate.
Daily Use
EN
18