Vector e-bike, Manual

Page: 30 / 46

Battery Charge
Connect the Vector original charger to the bike and the power outlet (240 V AC 50Hz / 110 V AC 60Hz).
ALWAYS CHARGE THE BATTERY WITH THE ORIGINAL VECTOR BATTERY CHARGER.
Note that both connectors, male and female, have notches on the inside that must match. Fully
introduce the male connector into the female connector and then rotate its housing clockwise a quarter
turn to secure it in place.
Once the charger is connected, a verification test will be done before it starts to charge automatically.
Once the charger is connected, the charging process starts automatically after 15 seconds. Do not forget
to turn off or unplug the charger after use. To do this you have to disconnect it from the network.
You can adjust the speed of the charging by turning the knob. We recommend 6-10A.
ONCE THE BATTERY IS CHARGED (GREEN INDICATOR), FIRST DISCONNECT THE CHARGER FROM THE
NETWORK, THEN DISCONNECT THE BATTERY CHARGER.
DO NOT INTERRUPT THE CHARGING PROCESS UNTIL THE BATTERY IS FULLY CHARGED. INTERRUPTING
THE BATTERY CHARGING PROCESS COULD CAUSE A LOSS OF CAPACITY OR PREMATURE BATTERY
FAILURE.
THE BATTERY MAY BE DAMAGED IF FULLY DISCHARGED (BELOW MINIMUM LEVEL OF USE).
Please DO NOT connect the charger to the power grid for a maximum of 6 hours