4
To Turn Machine On
Connect the propane/butane gas
cartridge to the main body. Make sure it
is locked into position. Turn the gas
supply on by turning the valve counter
clockwise, as shown in the diagram. To
start the machine, press the ignition
switch located on the left hand side of
the machine. It is necessary to keep the
machine on for about 10 seconds (if
water fogging) and/or 30 seconds (if oil
fogging) to warm up before opening the
chemical valve.
To Start Fogging
Once the machine has warmed to the
required temperature, turn the chemical
valve counter clockwise as shown in the
diagram below and press the trigger to
start fogging. When the trigger is
released, the fogging will pause.
Note: When oil fogging, please make sure
the oil has been consumed. Any oil still left
in the coil after use could cause it to block
and not work on the next session.
To Turn Machine Off
Release the trigger. Turn the chemical
supply valve clockwise to stop the
supply of chemical. Turn off the gas
supply by turning the valve clockwise as
shown on the diagram below. Remove
gas cartridge.
Note: When storing the machine, please
make sure no dilutant or chemicals are
left in the tanks.
Chemical Level
Indicator
