AI4.MUen.01
Vecteur Ai4 Owner’s Manual
Page : 4/8
IR Remote Control
The IR (infrared) Remote Control can be used to control the Ai4 volume and input signal
selection. The infrared remote control signal receiver is located under the Vecteur trademark
on the front panel. When you use the remote control, please point it to the infrared receiver
and do your best to it vertical to the receiver window for an optimal reception.
The Ai4 remote control has 4 buttons in order to select the source.
When one of these buttons is pressed, the instruction is transmitted to the amplifier and the
selected source light indicator flashes on the front panel.
The Ai4 remote control has 2 buttons for volume control.
By pressing the “+” key, the volume will be increased, and by pressing the “-“key, it will be
reduced. If you press on of them continuously, the volume will be changed continuously too.
During this operation, the signal indication light will flash quickly to indicate that the remote
control is working normally.
Use alkaline batteries inside the remote control. If the IR remote control transmission distance
reduces due to the depletion of the battery capacity, replace the batteries according to the
polarity instructions located inside the battery compartment on the back side of the remote
control. The incorrect battery installation will result in the remote control not working
correctly.
(1)
Input signal selection
(2)
Volume increase
(3)
Volume decrease
(4)
Remote control transmission window
(5)
Battery compartment
2
1
3
4
5
