Vectaire WHHRC180DC, Installation, Operating And Maintenance Instructions

Page: 18 / 29

Vectaire WHHRC180DC
13
User
Step
number Readout
(example)
Description Remark
installer
No.1 2,100 Current position/outlet volume [m 3 /h]
No.2 C 0 Message code operating condition C0 = No message
C3 = The input fan runs in constant pressure mode
C6 = The output fan runs in constant pressure mode
& &RUUHFWLRQPD[LPXPDLUÀRZ
No.3 bP.1 n.a.
No.4 tP.9 Temperature from atmosphere [°C] At negative temperature (below 0°C) then readout tP.9.
No.5 tS.21 Temperature from indoors [°C]
No.6 In.0 n.a.
No.7 u .156 Current input volume [m 3 /h]
No.8
U
.156 Current output volume [m
3
/h]
No.9 t.180 Current pressure input duct [Pa]
No.10 A.180 Current pressure output duct [Pa]
No.11 u0.0 Status frost protection
QRQH LPEDODQFH LQSXWIDQRII
No.12 St.9 Temperature to atmosphere [°C]
(Sensor not connected as standard) If not connected St.75
No.13 Pt.18 Temperature to indoors [°C]
(Sensor not connected as standard) If not connected Pt.75
Operating instructions Chapter 6
6.5 Readout settings
As standard the current position of the multiple switch and the
connected output volume are shown (Operational mode). On
the left the position of the multiple switch (position 1, 2 or 3) is
shown and to the right of the dot the volume of the output fan
is shown.
a = Position multiple switch
b = Volume output fan
6.5.1 Readout settings by the user
The user can read out other relevant data using keys " + ” and “ - ”
(step 0 to step 6). Step numbers are not shown on the display!
6HHWKHWDEOHEHORZIRUXVHUUHDGRXWZKHQQRNH\LVRSHUDWHG
for 5 minutes, the display automatically returns to operational
mode. Key “
+
´FDQEHXVHGWRVFUROOWKURXJKWKHPHQXNH\³
- ”
always takes you back to step 0. Modifying settings is not pos
sible in this situation.
6.5.2 Readout settings by the installer
A more comprehensive readout programme is available for the
installer. Pressing keys “
F ” and “ OK ” for 3 seconds calls up all
installer data. In this menu the values cannot
EHPRGL¿HG
Activating this menu always calls up step no. 7 (see table be
ORZXVLQJNH\³
+ ” the further installer and user data can be
displayed and key “ - ” takes you back to step no. 1.
After 5 minutes this menu automatically disappears and the
display will show the operational situation again.
,QWKHHYHQWRIDQHUURUWKHHUURUFRGHDSSHDUVRQWKHGLVSOD\
see also chapter 7.