58
GETTING TO KNOW YOUR RCS-9000F GTX1080
©Vecow RCS-9000F GTX1080 User Manual
2.4 Main Board Jumper Settings
You may configure your card to match the needs of your application by setting
jumpers. A jumper is a metal bridge used to close an electric circuit. It consists
of two metal pins and a small metal clip (often protected by a plastic cover) that
slides over the pins to connect them. To "close" a jumper, you connect the pins
to the clip. To "open" a jumper, you remove the clip. Sometimes a jumper will
have three pins, labeled 1, 2, and 3. In this case you would connect either pins 1
and 2 or 2 and 3. The figure below is the top view of the RCS-9000 main board.
It shows the location of the jumpers.
2.4.1 Front View of RCS-9000 Main Board With Jumper Location
1
3
4
6
JP3
JP5
JP4
JP2
JP6
JP1
Closed
Closed 2-3
1
2
3
