AW 12s-62s, 12a-62a
18
Electrical connections for AW-s models
1. The work must be done by a qualified electrician.
2. The fan heater is constructed for 230 VAC.
3. The fan heater must be connected to the mains with a permanent cable. A multi-pole breaker with a minimum of 3
mm between the poles must be used for the permanent connection.
4. Remove the lid to the connection box, as in photo 23.
5. Connections for the fan heater and the selection of fan speed are to be made according to the wiring diagram inside
the cover, see photo 24 or appendix E.
6. Use a hammer and a screwdriver to remove the required number of cable blanks (see photo 25). Break off the blanks
with pliers, as in photo 26.
Photo 25
Photo 26
7. The thermostat that controls the fan heater must be installed where it will not be affected by draughts from open doors
or windows, the airflow from the heater itself, etc.
Electrical connection of original accessories for AW-s models
1. Thermostat R31 (photo 27) with a temperature range of +7 to +30°C and protected
to IP20. One thermostat can control a maximum of three AW-s fan heaters.
2. Thermostat SR121/1 (photo 28) with a temperature range of 0-40°C and
protected to IP54. One thermostat can control a maximum of two AW-s fan heaters.
Photo 28 SR121/1
Photo 27 R31
Photo 23
Photo 24
Summary of Contents for AW 12a-62a
