LVP300 LED HD Video Processor
15
3
.
Other basic user operation
1
）
Brightness selection
（
Brt+
，
Brt-
）
LVP300
supports 64 level or 100 level brightness selection. According to“6.5 bright level”
selection
，
adjustment range has two kinds
：
0~64
or
0-100.
Factory default is
0-64.
To
make sure of full gray scale of output image, it always set as 64 (0-100 default value is 50) !
button
description
BRT-
Reduce
LVP300
output brightness
，
the lowest is 0.
BRT+
Increase
LVP300
output brightness, the highest is 64
or 100.
2
）
VGA input auto adjustment ( Auto )
When LVP300 is in one key switch status and current valid input signal is VGA,
press
Auto
button to adjust VGA input signal sampling parameters. Then the VGA
output image can be clear and full.
This operation is normally performed when a new VGA source is connected. Auto
adjustment time is depend on the signal status. Normally it’s less than 1 second.
Sometimes it’s necessary to perform several times until the output image is clear, full
and stable.
3
）
Full/ part display
（
Bypass
）
In signal switching status, press
Bypass
button to switch full and part display.
This function only works when current signal is
PC
input signal
（
VGA
/
DVI
/
HDMI ).
Fixed other signals to
Full
mode.
state description
Full
Full display,the input image is compressed and fully displayed on the led
screen and the indicator is off.
Part
Part display, the input image is not compressed.Only a part of it can be
displayed on the screen and the indicator is on.
