28
Using the settings menu
To...
Then....
open the settings menu
turn on the device holding down the button until "Settings" appears: the
Config units
setting appears
scroll the possible values or commands
Yes
and
No
briefly press the button
confirm the value or command and move to the
next setting
hold down the button until the value or command blinks once
exit the settings menu
select the setting
Exit settings
and then the command
Yes
or turn the
device off and back on: the first data page appears.
Note
: settings can only be scrolled forward. To change a previous setting, exit the settings menu and open it
again.
Example procedure
Following is the procedure to set
Engine instance
= 3
1. Turn on the device holding down the button until "Settings" appears: the
Config units
setting
appears.
2. Hold down the button until
No
blinks once: the
Config engine instance
setting appears.
3. Briefly press the button to view
Yes
, then hold it down until
Yes
blinks once: the
Engine instance
setting appears with the current value.
4. Briefly press the button to scroll values until
3
is displayed.
5. Hold down the button until it blinks once: the
Config analog inputs
setting appears.
Settings description
Setting
Description
Possible values/commands*
Speed
Speed units of measure
kmh
/
mph
/
kts
Temperature
Temperature units of measure
°C
/
°F
Pressure
Pressure units of measure
bar
/
PSI
/
kPA
Volume
Volume units of measure
Ltr
/
gal
Depth
Depth units of measure
ft
/
mtr
Engine
instance
Displayed data engine, NMEA 2000 code.
0
/
1
/
2
/
3
Input pin 8
Type of sensor data on input 1
l
Off
: no connected analog sensor
l
Trim
: trim, propeller tilt
l
Fresh
: fresh water level
l
Fuel
: fuel level
l
Rudder
: rudder angle
Input pin 9
Type of sensor data on input 2
Do sens.
calibration
Start sensor calibration
For information on sensor calibration, see "Sensors
calibration" on page 30.
Config RPM
Impulses per engine revolution
From 0.0 to 999.9 (default = 1.0)
Offset
Value to be added/subtracted from the depth to
compensate for the transducer position compared to the
waterline or keel
From -99.9 to + 99.9
UTC offset
Time zone
From -12 to +12 h
TimeFormat
Time format
l
12 h
l
24 h
General settings
Tachometer | Operating instruction v. 1.0 | A2C15587700 | 05-2017 | © 2017 Continental Automotive Switzerland AG
Summary of Contents for Ocean Link
