4.
Displays and Setting Possibilites
4.1 Basic Settings
The basic settings necessary for perfect operation can be selected in the settings
menu. These are obtained by pressing and holding the push-button key while
switching on the power supply of the display.
Display units:
Selection of display unit (see p. 8)
Baud rate:
Selection of baud rate (see p. 8)
Config inputs:
Setting the inputs (see p. 9)
Screens on / off:
Selection of displays (see p. 11)
Simulator mode:
Activation of simulation mode (see p. 11)
Exit setup:
Ending the setting menu (see p. 11)
In order to change a value (e.g. from No to Yes), press the push-button key briefly.
In order not to change a value, keep the push-button key pressed until the set val-
ue flashes once. Then release the push-button key immediately. Through this the
displayed setting is taken over. If the push-button key is not pressed, the displayed
setting is automatically taken over after 10 seconds.
4.1.1 Selection of the display units
The values for temperatures and pressures can be displayed alternatively in the
units °C/bar (METRIC) or °F/psi (ENGLISH). Selection of the units is carried out as
follows:
Example:
In the example shown the unit is changed from METRIC to ENGLISH.
4.1.2
Selection of the baud rate
The rate at which values are transmitted on the CAN bus can be set to 250 kB/s
(250 kBps) or alternatively to 500 kB/s (500 kBps). Selection of the baud rate is
carried out as follows:
BAUDRATE
250kBps
Press key
BAUDRATE
500kBps
10
DISPLAY UNITS
METRIC
Press key
DISPLAY UNITS
ENGLISH
