Mounting the unit
A
Do not install the unit where it would be subject to high temperature, such as from direct
sunlight, or from hot air, from the heater, or where it would be subject to dust, dirt or excessive
vibration. Sufficient air circulation is essential for the perfect function of the unit.
Front/rear mounting
The DVD Player can be properly installed either from “Front” (conventional DIN front-mount)
or “Rear” (JIN rear-mount installation, utilizing threaded screw holes at the sides of the unit
chassis). For details, refer to the following installation methods.
■
Note before installing, Fig. 3
❏
The unit must be installed horizontally. A deviation of + 30 degrees is possible. Larger
deviations may result in malfunctions.
❏
A rigid connection to the vehicle body is a prerequisite for correct functioning of the DVD
Player.
DIN mounting
The DVD Player can be installed into a vehicle’s DIN radio slot using the installation sleeve
provided.
■
Installing the unit
1. Insert metal sleeve into the DIN opening and press appropriate tags outwards with a
screwdriver (Fig. 4 - 5). Take care not to damage hidden parts in the dashboard.
2. Be sure you have connected all required cables to the player.
3. Push the player into the mounting frame until it engages.
■
Removing the unit, Fig. 6 - 7
1. Remove the detachable operating panel. Push up the metal holder until it clicks in.
2. Insert a finger into the groove in the front of the frame and push down a little to unlock
the frame. Then pull out to remove the frame.
(When reattaching the frame, point the side with the groove downwards.)
3. Insert the supplied removal tools into the grooves at both sides of the unit (1).
4. Push the removal tools up or down a little until they engage in the small brackets at either
side of the unit (2).
5. Pull the removal tools smoothly to remove the unit from the dashboard (3).
JIN mounting, Fig. 9
1. Remove the two small brackets on either side of the unit with a screw driver.
2. Remove the frame as described under “Removing the unit”.
3. Fasten the vehicle specific mounting brackets to the unit. Select a position where the screw
holes of the bracket and the screw holes of the main unit become aligned and tighten the
screws at 2 places on each side.
Use either screws M5 x 6 mm or M4 x 6 mm, depending on the shape of the screw holes in
the bracket.
Note:
The mounting sleeve and the outer frame are not used for JIN mounting.
INSTALLATION INSTRUCTIONS
11
English
Summary of Contents for DV 6100
Page 3: ...3 1 2 3...
