13
English
Setting Navigation Detect Level
This function allows to configure the naviga-
tion message detection level (Nav mute wire).
1- Long press MUTE.
2- Select NAV LVL with the
keys.
3- Use the keys, to select LOW (default
value) or HIGH.
4- Press ESC to enter the value.
Note :
You need to select the value according
to the type of the connected equipment.
Setting the SDVC
SDVC automatically adjust the volume
according to the speed of the car. You can
switch off this function or select one of the five
curves that suit your car. Level 1 gives a smaller
increase while level 5 gives a greater increase.
1- Long press MUTE.
2- Select SDVC TYPE with the
keys.
3- Use the keys, to set Off, curve 1, curve 2,
curve 3, curve 4 or curve 5.
4- Press ESC to enter the value.
Note 1:
You can use this function only when
the speed signal is connected and calibrated
(see SDVC and Calibrating the speed in pages
6 and 10 respectively).
Note 2 :
You choose a SDVC curve according
to the state of your environment noise.
Launching Loudspeakers Installation
Use this function to verify the installation of
your loudspeakers.
1- Short press ENTER.
2- Select INSTALL with the
keys.
3- Press ENTER to launch the function: a beep
is emitted for each well installed
loudspeaker.
4- Switch OFF/ON the set.
Setting the Light Display Brightness
This source independent function adjusts the
brightness of light display between its min. and
max. value (1 to 10).
1- Long press MUTE.
2- Select BRIGHTNESS with the arrows
.
3- Use the arrows to select a value.
4- Press ESC to enter the value.
TUNER
You can set the radio stations options after
selecting the tuner source. Then by either a
short or long press on ENTER, you get two
different tuner menus (see cover pages).
Search Left/Search Right
Use the
keys to scroll through the selec-
ted waveband.
Search Up/Search Down
Use the keys to scroll through the memo-
rised stations list of the waveband.
TUNER MENU
1- Press the SOURCE key to select TUNER
2- Short press ENTER to get to TUNER MENU.
3- Use the
keys, to select an option.
4- Use the keys to set the option value.
5- Press ESC to enter the value.
Selecting a waveband
With this function, you can select a band in a
scrolling list.
1- Short press ENTER.
2- Select BAND with the
keys.
3- Select the stations memorised in the presets
with the keys:
- FM AST
Automatically stored FM
stations list
- FM 1,2,3.
Manual presets FM
- FM memo
RDS alphabetical list
- LW
Manual presets LM
- MW AST
Automatically stored
MW stations list
- MW 1,2,3.
Manual presets MW
4- Press ESC to enter the value.
Note :
The stations in FM memo are only
stations created and updated by RDS memo.
AN2001-2L-Eng.pm7
11/20/02, 3:32 PM
13
