12
Switching the Warning LED
This function enables/disables the blinking LED
(contact Off or remove front).
1- Long press MUTE.
2- Select WARN LED using the
keys.
3- Use the keys, to select ON (default value)
or OFF.
4- Press ESC to enter the value.
Setting the Chimes Audio Level
This function allows you to set the chimes audio
level.
1- Long press MUTE.
2- Select CHIMES LVL with the
keys.
3- Use the keys, to select a value between
1 and 5 (2=default value).
4- Press ESC to enter the value.
Selecting Chimes
This function allows you to select pre-recorded
chimes for audible system feedback.
1- Long press MUTE.
2- Select CHIMES SET with the
keys.
3- Short press ENTER to get to the chimes
menu
4- Use the
keys, to select a chime type:
keypress, confirmation, announcement,
warning, errors, welcome, bye-bye.
5- Use the keys to select a bleep which will
be associated to the previously selected
chime type.
6- Press ESC to enter the value.
Setting the Message Audio Level
This function allows you to adapt the messages
audio level.
1- Long press MUTE.
2- Select TA VOLUME with the
keys.
3- Use the keys, to select a value.
4- Press ESC to enter the value.
Setting a Phone Equipment
This function enables/disables the phone
detection for the car radio.
1- Long press MUTE.
2- Select PHONE with the
keys.
3- Use the keys, to select NO (default value),
Mute or IN.
4- Press ESC to enter the value.
Note:
Set to IN if the Tel audio is connected to
the Tel IN wire or via the D1 connector. In some
cases, you need to set the phone detection level
(contact dealer).
Setting the Phone Detection Level
This function allows to configure the phone
message detection level (Tel mute wire).
1- Long press MUTE.
2- Select PHONE LVL with the
keys.
3- Use the keys, to select LOW (default
value) or HIGH.
4- Press ESC to enter the value.
Note :
You need to select the value according
to the connected equipment (telephone,
loudspeakers).
Setting the Phone Volume
This source independent function adjusts the
phone level between its min. and max. value (-
30 to +30).
1- Short press MUTE.
2- Select PHONE VOL with the
keys.
3- Use the keys to select a value (0 equal
the default value).
4- Press ESC to enter the value.
Setting a Navigation System
This function enables/disables the navigation
messages detection for the car radio.
1- Long press MUTE.
2- Select NAV with the
keys.
3- Use the keys, to select NO (default value),
Mute or IN.
4- Press ESC to enter the value.
Note :
Set to IN if the Nav audio (low level) is
connected to the AUX IN at connector D2 wires.
In some cases, you need to set the navigation
detection level (contact your dealer to fill in the
next option).
AN2001-2L-Eng.pm7
11/20/02, 3:32 PM
12