9
* Depending on version
SECURITY
For theft protection this set is provided with the
following security features :
DETACHABLE FRONT
Take the detachable front with you when leaving
the car. Keep it in its protective box.
Always replace the detachable front before starting
to drive.
Removing the front (See page 3, figure B)
• Press
to flip down the detachable front.
• Pull at the left hand corner of the detachable
front to remove the front.
Replacing the front (See page 3, figure C)
• Insert the detachable front starting with the right-
hand side of the set.
• Push the detachable front until it clicks into
position.
LOCKING THE DETACHABLE FRONT (See
page 3, figure E)
The detachable front can be locked by a D2 x10
screw.
• Remove the trimplate
• Flip down the detachable front.
• Insert a D2 x10 screw (inside the accessories
bag) in position 1 .
SECURITY LIGHT
• The LED flashes when the detachable front is
removed when the ignition is off. You can switch
off the flashing warning light. See 'SAM' (page
14), option 'LED' .
IDENTIFICATION NUMBER
This set has a unique identification number (stated
on the 'Security card'). This card is required as a
proof of ownership when the set is stolen, when
the detachable front is lost or when requesting
service.
• Remove the 'Security card' before installing the
set. Do not keep the 'Security Card' in your car.
AUDIO
ON/OFF
• Press
to switch on the set. Press
for more than 2 seconds to switch off the set.
VOLUME
Please make sure you can still hear the traffic
(horns, sirens........)
• Press
/
to adjust the volume. The volume
automatically increases or decreases if the
SDVC connection has been installed and
selected (See INSTALLATION, page 5).
Note : You can adjust the start-up volume. When
the start-up volume is set to maximum level, it
may be extremly loud when you switch on the
set. See 'SAM' (page 14), option 'START'.
MUTE
• Press
to mute/demute the sound when
the set is switched on.
Note : You can adjust the mute level.The volume
may be louder during mute when the mute level
is higher (e.g. 16) than the current volume (e.g.
5). See 'SAM' (page 14), option 'MUTE'.
3D SURROUND SOUND* (only applicable for
CD, CD Changer* and MP3*)
• Press
* for more than 2 seconds to
activate/deactivate 3D surround sound.
AUDIO MODE SETTING
• Press
* or
to select
desired audio mode.
• Press
or
to adjust the selected
audio mode.
– BASS : Bass (-7...+7)
– TRE : Treble (-7...+7)
– BAL : Balance (-7...+7)
– FAD : Fader (-7...+7)
– Sound Style (BASS-TRE, ORIGINAL, JAZZ,
VOCAL, POP, CLASSIC, ROCK)
After 5 seconds the display goes back to the
last mode of operation.
Adjustment of Bass and Treble setting is only
possible when BASS-TRE is selected as the
sound style.
Sound style are set for each source* (Radio,
CD/MP3* and CD Changer*).
BASS BOOST SYSTEMS
• Press
to select desired bass boost (not
applicable when ORIGINAL is selected as the
sound style).
004-16 Mid_Eng
8/15/02, 6:48 PM
9
