5
* Depending on version
BEFORE YOU START....
Thank you for purchasing this VDO Dayton
product which has been designed and
manufactured to the highest standards and
subjected to rigorous testing.
Kindly familiarise yourself with the product by
reading this user manual. Keep this manual handy
in your car for future reference.
ENVIRONMENT
This booklet is printed on low-chlorine recyclable
paper.
IMPORTANT
This device has been designed and produced
according to applicable Safety Regulations.
Please read carefully the instruction manual and
use the device as intended.
CONTENTS PAGE
INSTALLATION ................................................ 5
PREPARATION ................................................ 5
MOUNTING ..................................................... 7
FRONT PANEL PRESENTATION ................... 8
SECURITY ....................................................... 9
AUDIO .............................................................. 9
RADIO ............................................................ 10
RADIO DATA SYSTEM (RDS) ON FM ......... 11
CASSETTE PLAYER ...................................... 12
CD PLAYER AND CD CHANGER ................ 12
SPECIAL FUNCTIONS .................................. 13
SAM (Software Access Mode) ...................... 14
TROUBLE SHOOTING ................................. 16
Complies with 21 CFR 1040.10
INSTALLATION
If your car is equipped with ISO connectors,
simply insert them in the connectors of the car
radio. If not, you can use an adaptor cable (Refer
to the table on the separate installation manual).
Ensure all cables are installed so that they cannot
be damaged by sharp edges or moving parts.
PREPARATION
Voltage and polarity:
The set must be connected
to a 12V car battery with negative terminal to
earth (car chassis). Installation in vehicles not
fulfilling these requirements could result in
malfunction, damage or fire.
Warning:
To prevent shor t-circuiting,
disconnect the negative car battery terminal
until the set has been mounted and
connected (fig.1 See separate installation
card).
CONNECTOR A (fig.2)
Power supply connections
•
Red wire A7 :
Connect to a permanent 12V
supply. This is the main power supply. Ensure
this connection can handle a current of 10A.
•
Yellow/red wire A4 :
Connect to a switched
12V supply (switched on/off by car ignition).
•
Brown wire A8:
Connect to earth (car chassis).
Optional connections (fig. 2)
•
SDVC (Speed Dependent Volume Control)*
:
SDVC automatically increases and decreases
the volume as a result of the car's speed.
• Connect pin A1 to a signal from the
speedometer of your car. Some cars are
already prepared for it (e.g. certain VW &
Vauxhall/Opel cars), please consult your dealer.
If not, you may need a more detailed installation
requiring extra equipment to enable your car to
become compatible.
This can only be accomplished by
persons familiar with automotive
electrical and mechanical systems.
After Connection, see "SPECIAL
FUNCTIONS' (page 13) for calibration
procedure.
01-2202-2502.p65
14/04/2001, 10:02 AM
5