www.videocamerasecurity.com
VCS-PTZCR detailed operating instruction
©2010
www.VCSDVR.com
3/4
The third step, the memory parade path. Press "PATTERN" button 3 seconds into the parade path of preset
points, the beginning of setting mode, enter a number 1,2,3,2,1, respectively, the camera will reach the preset
point position, that is to guide the camera to go a complete manual parade between 3 points, and then press
button "PATTERN" 3 seconds to complete the setup.
The fourth step; press "RUN" button to start to run this parade pattern. The camera will follow a ready
pre-set path to start parade, and also will stay in the running (the stay location is the all preset points). To exit
the cruise mode, just press"RUN" button.
5. To set the starting point to the end of the parade path
Methods: The first step, set preset points. Click "PRSET" button 3 seconds to enter preset point setting mode, respectively, enter
the letters AB directly to set start and end point. If you are running and found anti-AB path, then re-set the AB, can be
exchanged AB location.
The second step; press "AUTO" key to run the AB model. Camera repeatedly uniform parade between AB, press S1-S4 can
change the speed of parade. To stop the parade , press "ENTER" button.
6. To set the baud rate and protocol
Method: Press "SETUP" button 3 seconds into camera’s set the baud rate and protocol mode, use the "up-down “key to select
"P" protocol or "D" protocol, use the "left-right" key to change the baud rate, there are 1200 bps, 2400 bps, 4800 bps, 9600 bps
optional, and then press "ENTER" button. (Note: Pelco-D protocol is only supported at this time)
4. Multi-cameras Selection Control
The first step, set your camera IDs with the dip switch settings on your PTZ (refer to your PTZ manual).
The second step, select the camera. Click "CAM" key to enter the ball machine selection mode, respectively,
enter the numbers 0-9, can directly select the 9-below camera, do not need to press "ENTER" button to confirm.
To set up nine or more numbered camera, press "-/--" key, you can enter values greater than 9, to delete the
wrong, press "C" key, to confirm press "ENTER" key, then this number of camera choose successfully.
The third step is to use other keys to control on the camera’s operations.
5.
Highlight
1. A PTZ controller is defaulted can control 32 cameras.
2. "A" and "B" can only be used to set the start and end location of the two cruise mode, and between the "A"
and "B" it can not set other preset points. To set more pre-set points, refer to Article 4 for set up.
3. Remote control of other key features please refer to the original manual.
6. Particular Settings
1. Set the PTZ camera address:
a. press the CAM key, select the address number to set the camera.
b. press PRESET, SETUP button for 3 seconds each.
2. Baud rate settings:
a. press the SETUP button to enter the baud rate and protocol settings, choose the baud rate and protocol to use.
. (note: Pelco-D protocol is only supported at this time)
