39
•Jumper Setup as master or Slave, Following the
`
Direction of Surface of Hard Disk.
•Jumper Located at Hard Disk Data Cable or
1
Rear Side of Hard Disk.
•If one hard disk Installation, setup as Master
If
two hard disk Installation, second one setup as slave.
Jumper Setup as Master or Slave
Jumper Setup as Master or Slave
Jumper Setup as Master or Slave
Jumper Setup as Master or Slave
Example of Samsung HDD Jumper Setup
Example of Samsung HDD Jumper Setup
Example of Samsung HDD Jumper Setup
Example of Samsung HDD Jumper Setup
• Refer to general pin setting in jumper pin setting on HDD surface.
• When one HDD install, setup pin as master and connect pin
1
at
the left end of jumper.
• When two HDD Install or additional Install, first one setup as
1
master
and the other is for slave. slave setup has no pin.
• When more than two HDD install, setup as master or slave
1
to connect one IDE cable at the same method of above.
!!Please use hard disk which possible to supply higher than
UDMA66
.!!
‼
When hard disk add or exchange,
Must system off properly
(System off by power button)
. If not, it
’
s a cause of fatal hard
disk error.
‼
IDE Cable Connection to Main Board
IDE Cable Connection to Main Board
IDE Cable Connection to Main Board
IDE Cable Connection to Main Board
• Confirm the IDE cable inside of product
• Among the three connector, Indicated blue
color
1
connector must be connected
with main board. other
1
connectors
connected with HDD
* HDD Installation
SUPPLEMENT
SUPPLEMENT
SUPPLEMENT
SUPPLEMENT