VBG 14, Mounting Instructions

Page: 3 / 4

3
Fitting the socket
1. Remove the insert. To prevent the terminals from
falling out, wind a bit of electrical tape around it.
2. Slip the conduit entries onto the cable - sealed nut
- washer - gasket.
3. If both conduit entries are not to be used, fit a plug
with washer and gasket.
4. Pull each cable through its respective entry point.
Pull it out as much as necessary to work comfortably
with the connections.
5. Strip the cable casing back about 60 mm.
6. Check and label the wires by function.
7. Strip the wires about 5 mm. Fit cable shoes with the
recommended dimensions.
8. Set the hose clamp 85 mm from the cable shoes and
tighten the screws until it is fixed on the cable.
9. Connect the wires to the blade connectors in the
cartridge as per the wiring plan. Spray with VBG
Electro Oil onto the cable shoes and connector blades
to prevent corrosion.
10. Place the insert in the box and affix it using two
screws.
11. Check by pulling the cable that the hose clamp is
properly mounted.
12. Insert and tighten the conduit entry with moderate
force so that it seals.
13. Where applicable, install the lock hook on the lower
edge.
• A holder for the socket when the trailer is uncoupled
can be fitted on the drawbar, part no. 28-030100.
• Terminals 1 and 12 require larger cable shoes (9.5
mm). The cable dimension shall always be chosen
taking power consumption into consideration. When
dimensioning, keep in mind any extra equipment that
may be fitted at a later date.
Holder for socket
85 mm
Strip 5 mm
1,5 mm
1 Earth Earth Earth
2 A L Flashers A L Flashers A L Flashers B Aux
3 A R Flashers A R Flashers A R Flashers B Aux
4 A Brake Lights A Brake Lights A Brake Lights B Aux
5 A L Tail Lights A L Tail Lights A L Tail Lights B Aux
6 A R Tail Lights A R Tail Lights B Aux A R Tail Lights B Aux
7 A Reversing B Fog Light A Reversing B Fog Light A Reversing B Fog Light
8 A Aux B Aux A Aux A Aux B Aux
9 A Aux A Aux B Aux A Aux B Aux
10 A Aux A Aux B Aux A Aux B Aux
11 A Aux A Aux B Aux A Aux B Aux
12 Charging Current Charging Current Charging Current
1 Earth Earth Earth
2 A L Flashers A L Flashers A L Flashers B Aux
3 A R Flashers A R Flashers A R Flashers B Aux
4 A Brake Lights A Brake Lights A Brake Lights B Aux
5 A L Tail Lights A L Tail Lights A L Tail Lights B Aux
6 A R Tail Lights A R Tail Lights B Aux A R Tail Lights B Aux
7 A Reversing B Fog Light A Reversing B Fog Light A Reversing B Fog Light
8 A Aux B Aux A Aux A Aux B Aux
9 A Aux A Aux B Aux A Aux B Aux
10 A Aux A Aux B Aux A Aux B Aux
11 A Aux A Aux B Aux A Aux B Aux
12 Charging Current Charging Current Charging Current
Wiring plan
Ter. 14-terminal (black ) 17-terminal (red) 22-terminal (green)