Page 3 / 5
221021
Sensor Adjustment Lower For Short Coverage
Sensor Adjustment Higher For Long Coverage
Fig. 5
Fig. 4
Fig. 2
Fig. 3
Adjusting the Light Head (B):
2.
Keep the light heads (B) 30˚ below horizontal to avoid water d
amage and electrical shock.
Sensitivity of Motion Sensor
● You can adjust the sensitivity of the motion sensor b
y using the “SENSITIVITY” selector located on the right
side of the bottom surface of the sensor. (See Fig. 4)
● Adjust motion sensor sensitivity to achieve desired performance.
● Approximate range for each setting from 10ft to 70ft.
1.Gently grasp the light heads (B) and tilt them left or right to adjust the light coverage area. Keep the light heads (B) at
least 1” (25mm) away from the sensor.(See Fig. 5)
B
Functions and Operations
Choose a mode by sliding the switch on the bottom of the sensor of the fixture. (See Fig.4)
Note: When power is first applied, the light will be on and warm up lasts 30 seconds.
1. TEST MODE (daytime and nighttime operation.)
● Rotate Time knob arrow on the left side of the sensor head to the "TEST" position.
● The light turns to high-level brightness when motion is detected, and stays on as long as the motion continues.
Then it reverts back to low-level brightness about 5 seconds after motion is no longer detected.
2. OFF MODE (nighttime operation only)
● In "OFF" mode, slide the Time Delay knob to the desired time(30s/1min/3min). At dusk, the light stays off,
the light turns to high-level brightness when motion is detected, and stays on as long as motion continues.
When the motion is no longer detected, it remains on for the predetermined shut-off delay time you set
(30s/1min/3min), and then turns off automatically.
● The light turns off automatically at dawn.
3. AUTO MODE (nighttime operation only)
● To “AUTO” mode, rotate “Time” knob to the desired time setting (30s/1min/3min). At dusk, the light turns on
to low-level brightness. When motion is detected, the light turns to high-level brightness and stays on as long
as motion continues. When the motion is no longer detected, the light at high-level brightness remains on for
the predetermined time you set (30s/1min/3min), then switches back to low-level brightness automatically.
● The light turns off automatically at dawn.
