Cross Bar Unit
X1
Mounting Screw
X2
Wire Connector
X3
Ball Nut
X2
Rubber Pad
X2
AA
BB
CC
DD
EE
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
T0575 / T0576
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
Page 1 of 5
200313
Hardware Package (
included
):
Important to Know
1. Read all instructions carefully before installation and operation.
2. If you are not familiar with state and local electrical codes, it is
recommended that you consult with a qualified electrician.
3. Before installation, shut off power at the main fuse or circuit
breaker box. Be aware that simply turning off the wall switch is
not sufficient to prevent an electrical shock.
4. This fixture requires a 120 VAC, 60 Hz power source.
5. Do not attempt to take the lantern apart; there are no
serviceable parts inside.
6. To avoid sensor damage by lightning or electrical surge, make
sure the grounding wire is securely connected.
7. For general safety and to avoid any possible damage to the
sensor, be sure the power is switched "off" before replacing the
bulb.
8. Compatible with LED dimmable bulb.
Maximum Wattage: 60W
Incandescent
Bulb or 20W LED
Dimmable Bulb
Work Temperature: -4°F~104°F
Features
1. Energy saving fixture.
2. Use dim-to-full brightness where
dim-illumination is preferred, such as your
front entrance. Use off-to-full brightness
where off/on illumination is preferred, such
as your backyard.
3. When in manual override mode, use wall
switch to keep the light ON till dawn.wn.
