Vaxcel T0362 Assembly And Installation Instructions Download Page 2

Page 2 / 4

1. Take a side glass panel and gently place the side glass panel into 

    the metal frame in place, then pressing the clips of the metal frame 

    to secure the side glass panel. (See Fig. 1)

2. Repeat this process to complete all glass panel installation of side 

    glass panels and front glass panel.

3. Attach the metal frame back to the main fixture, secure it with two 

    set screw.

4. Thread two headless screws through the mounting plate, and then 

    secure them with four lock nuts (two on each side of the mounting 

    plate). Adjust the length of the headless screws if necessary.

    Note: Make sure that the headless screws are lined up 

              horizontally to make the fixture level.

5. Attach mounting plate to the outlet box using two mounting screws.

6. Pull out the wires and grounding wire from the outlet box. Make 

    wire connections using the wire nuts as follows:

    ---Connect the hot wire (usually black insulation) from the fixture to 

        the black wire from the power source.

    ---Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source.

    ---Attach the fixture grounding wire (usually green insulation or bare wire) to the mounting plate with the green 

       grounding screw, and then connect it to the house grounding wire with the wire nut.

    Carefully put the wires back into the outlet box.

7. Attach the back plate to the mounting plate by inserting the headless screws, and then secure it with two rubber pads 

    and two ball nuts.    

    

NOTE: With silicone caulking compound, caulk completely around where the back plate meets with the wall 

                surface to prevent water from seeping into the outlet box.

8. Open the door of the fixture by pushing up the latch. Install bulbs (not included). See relamping label at socket area or 

     packaging for maximum allowed wattage. Close the door of the fixture by pulling down the latch.

 

 

Installation Steps

Turn off the power at fuse or circuit box.

 

 

 

 

 

 

Main Fixture 

Back plate

Ball Nut (H)

Rubber Pad (G)

Side Glass Panel(J)

Metal Frame

Clip

House Grounding Wire

Green Grounding Screw (C)

Wire Nut (E)

Mounting Screw (B)

Headless Screw (D)

Outlet Box

Fixture Wire

Lock Nut (F)

Mounting Plate (A)

Fixture Grounding Wire

Bulb Type A Max.60W

(not included)

Door

Front Glass Panel (I)

Set Screw

Latch

Fig. 1

Clip

Glass Panel

Turn on the power at fuse or circuit box

171022

Clip

Reviews: