Page 2 / 3
Installation Steps
Turn off the power at fuse or circuit box.
Turn on the power at fuse or circuit box.
Photocell
Mounting Strap
Outlet Box
Wire Nut
Back Plate
Mounting Screw
Light Head
Fixture Mounting Screw
FRONT
Decorative cover
1. Install the mounting strap to the outlet box with the stamped word “FRONT” facing away from the outlet box, using
two mounting screws that best fit the outlet box. Back plate should sit flush against wall surface when secured.
(Choose one matching pair of suitable mounting screws from the 3 pairs provided)
2. Pull out the source wires from the outlet box. Make wire connections using wire nuts as follows:
---Connect the black wire from the fixture to the “hot” wire from the power source. (usually black)
---Connect the white wire from the fixture to the neutral wire from the power source. (usually white)
---Connect the grounding wire from the fixture to the grounding wire from the power source. (usually green / yellow
insulation)
Carefully tuck the wires back into the outlet box.
3. Attach the back plate of the light to the mounting strap, secure it with the fixture mounting screw.
4. Push the decorative cover firmly into the fixture mounting screw hole on the light.
5. With silicone caulking compound, caulk completely around where the back plate meets the wall surface.
CAUTION: Be sure to caulk completely where the back plate meets the wall surface to prevent water from
seeping into the outlet box.
6. Gently grasp the light heads and move them up or down, left or right to adjust the light coverage area. Keep the
light heads 30˚ below horizontal to avoid water damage a
nd electrical shock.
IMPORTANT:
The fixture features a photocell sensor which enables the light to turn on at dusk and off at dawn automatically.
Note: When power is first applied, the light will turn on immediately. Wait for 15 seconds to allow the sensor to
warm up.
170221
The following parts are available for re-order if damaged or missing.
Mounting Strap
Wire Nut X3
Decorative cover
Fixture Mounting Screw
Troubleshooting
---The light does not come on at all:
1. Make sure the wall switch and circuit breaker are on.
2. Make sure the wiring is correct.
Mounting Screw X2
#8/32X1/2 in
Mounting Screw X2
#6/32 X1/2 in
Mounting Screw X2
#10/24 X1/4 in
Assembly Kit
5349MM (1 SET) FOR T0327
5350MM (1 SET) FOR T0328
