Vax W85-PP-T Dual Power Pro, User Manual, Page: 12 / 20

Using your machine
Washing hard floors
Emptying the dirty water tank
CAUTION:
To prevent damage to wood floors and other hard floors, follow the flooring manufacturer’s
cleaning recommendations. Inspect floor surface for worn finish, bare wood or separated joints.
If it’s not recommended to use the carpet washer on floors if any of these conditions exist.
IMPORTANT: Before attaching the hard floor squeegee onto carpet washer, remove tanks or make sure tanks are empty
before lying the carpet washer on its back.
CAUTION: Always unplug the carpet washer before performing any maintenance/troubleshooting checks.
Lie carpet washer on its back, line
up squeegee with nozzle.
Press dirty water tank
release latch, pull to
remove dirty water tank.
To re-fit, tilt dirty water tank and line
up onto carpet washer. Push back
until it clicks into place.
Hook front of squeegee onto edge
of nozzle.
Pull and lift dirty water
tank clip to release lid.
Lift to remove dirty water
tank lid.
Push squeegee under nozzle until it
clicks into place.
Empty dirty water over
the sink. Rinse dirty water
tank and lid under water
to remove dirt/debris.
Clean the filter screen
located at the back of the
dirty water tank.
Empty and rinse out clean
and dirty water tanks and
leave to air dry before
replacing. Do not leave
solution stored in the tanks
between uses.
IMPORTANT