4
assembly/operation
3. Assembly
Putting your cleaner together
Stand the base in the upright position. Assemble the mid
section onto the base, taking care not to trap internal
wire (Fig 3/1).
Insert the three nuts into the recesses located on the left
and right sides of the base and into the recess located in
the middle of the back of the base.
While holding the nuts in place insert screws through the
front of the mid section and tighten (Fig 3/2) using a
crosshead screwdriver.
Slide the upper handle down onto the unit. Insert nut into
the recess in the back of the upper handle. While holding
the nut in place insert the screw through the front of the
upper handle and tighten.
Run the cord wire above the upper cord hook and secure
with the cord clip (Fig 3/3).
4. Operation
IMPORTANT: Turn off when emptying and filling
the reservoir.
Grasp the clean water tank under the handle and press
the handle release lever upward (Fig 4/1).
Tilt the clean water tank away from the cleaner and
remove (Fig 4/2).
Unscrew the measuring cap from the rear of the clean
water tank (Fig 4/3).
Fill the bottle cap or measuring cap 4 times with Vax
carpet cleaning solution and pour into the clean water
tank (Fig 4/4).
Fig.3/1
Fig.4/1
Fig.4/2
Fig.3/2
Fig.4/3
Fig.3/3
!
vax.co.uk
VRS14W_User Guide_v1_V-024U User Guide 16/04/2012 16:36 Page 4
All manuals and user guides at all-guides.com
