WARNING: Make sure that the microfiber filter (P) or the sponge filter
(Q) are properly fitted between upper filter holder and lower
filter cover, and that the solid filter (R) is placed correctly. If not,
the handgrip (T) cann ot be hooked safely.
picture 7
picture 8
picture 9
picture 10
picture 11
7.1
Using the appliance as a vacuum cleaner
7
OPERATION
7.2
Vacuuming with water filter
To select the suction power (from level 1 to level 4), press the remote
suction button (27) on the handgrip (23) at short intervals; the
selected suction power level LED indicator (28) will light up. (Pictures
12-13)
It is possible to change the power level both when the suction is on
and off.
To switch the vacuum on and off, hold down the remote suction but-
ton (27) for about two seconds. If the quick connector (24) is pulled
out, the suction power level will restart from level 1 the next time the
appliance is used.
CAUTION! Never vacuum if the microfibre filter (P) is not installed.
For best filtration results, add water to the machine tank (M). The
water filtration allows you to
“capture” the dirt so that the outbound air
always remains clean and therefore you clean more effectively.
Proceed as in chapter
“6.1 Preparing the vacuum cleaner” then
replace the microfibre filter (P) with the sponge filter (Q) (chapter
“6.3
Replacing the filter
”) (picture 14). Add one litre of normal tap water to
the tank until you reach the MAX level shown on the tank (picture 15).
CAUTION! Do not put detergents or inflammable substances in the
tank. Never vacuum if the sponge filter (Q) is not installed.
You can add Aroma to the machine tank. This prevents bad odours or
smell from the tank. Use the product according to the instructions for
use shown on the label.
EN
7
8
Summary of Contents for VCST-01
Page 1: ......
