Vax V-077, Instruction Manual

Page: 5 / 12

3. How to Assemble
IMPORTANT: Always unplug the vacuum cleaner
from the electrical outlet before assembling or
removing accessories.
1. Insert the flexible hose into the inlet on the main
body of the vacuum cleaner. Push it in until it
clicks into position (Fig.3/1).
2. Join the extension tubes together and push onto
the end of the handle (Fig.3/2).
3. Fit the floor tool by pushing it on to the extension
tube (Fig.3/3).
4. How to Operate
On/off button
Insert the power plug into the electrical outlet. Make
sure the vacuum cleaner is switched off. Press the
on/off button located on the top of the cleaner to
switch on the vacuum cleaner, and press the button
again to turn the vacuum cleaner off.
Cord Rewind
To rewind the power cord, press the cord rewind
button, located on the top of the vacuum cleaner, and
guide the power cord with one hand. This will prevent
the cord from whipping which could cause damage or
injury.
Variable Power
Located between the on/off and cord rewind buttons
there is a variable power dial. Slide this clockwise and
anti-clockwise to adjust the suction power.
Carry Handle
Use the carry handle at the rear end of the vacuum
cleaner to move from room to room.
Hose Storage
For convenience there are two slots located on the
bottom of the vacuum cleaner where the floor tool can
be parked for carrying and storage.
5. Accessories
The accessories can be attached directly to the
handle by removing the tubes and floor head tool and
pushing in the desired accessory.
The accessories can also be attached to one or two
extension tubes for extra reach. Remove the floor tool
and push on the desired accessory.
2in1 Tool
Crevice tool: For crevices, corners and cracks
etc.
Dusting brush: Rotate the end of the 2in1 tool
until it clicks. For delicate surfaces and skirting
boards
How to Assemble / How to Operate
5
Fig.3/1
Fig.3/2
Fig.3/3
VAX.V-077 User Guide .qxd 1/8/06 15:22 Page 6