Using your machine
Before you begin cleaning
• Always switch off and unplug the vacuum cleaner before connecting or disconnecting the hose/attachments, or removing
and emptying the dirt container.
• The vacuum cleaner is equipped with a thermal cut-out. If for any reason the vacuum cleaner does overheat the thermostat
will automatically turn the vacuum cleaner off. If this happens, switch the vacuum cleaner off and unplug from electrical
socket. Remove and empty the dirt container also check the vacuum cleaner for blockages. Allow the vacuum cleaner to
cool for approximately 1 hour (if you have cleaned the filters please wait 24 hours for the filters to fully dry before putting
back into the vacuum).
• Pre motor filters require cleaning at least every 3 months.
• If the vacuum cleaner is blocked, switch off and unplug before removing the blockage.
• When using the accessories always make sure the machine is stood in the upright position.
Taking care of your machine
Telescopic extension tube
Remove hose end
from the floorhead.
Remove telescopic
extension tube.
Choose an accessory.
Attach accessory
to hose end.
3-in-1 tool converts into:
a = Crevice tool
b = Upholstery tool
c = Dusting brush
a
b
c
Attach accessory to
telescopic extension tube.
Attaching the hose
Attach hose to telescopic
extension tube.
Using accessories
NOTE:
The TurboTool, 3-in-1 crevice tool, dusting brush and upholstery tool can all be attached to the telescopic tube
or directly to the hose.
Use the tool connector when attaching the flexi crevice or flat upholstery tool (some models only).
Emptying and cleaning the dirt container
How to use the air vent
Cleaning the HEPA pre-motor filter
Press the dirt container release button and pull
to remove the dirt container.
Slide vent cover open to decrease suction,
if required on high piled carpets.
Turn the dirt container lid
anti-clockwise…
Tap the filter over a bin
to release any dirt.
Hold dirt container over a bin and press the dirt
container release button allowing dirt to fall out.
Close the vent cover to increase suction,
for maximum cleaning on hard floors.
…and lift to remove.
Wash the filter under
running water (40°C max).
Grasp tab on filter
and pull to remove.
Leave to fully dry for at
least 24 hours before
putting back into the
vacuum cleaner.
40°C max
tap
!
!
!
!
24hr
MAX
40˚C
!
MAX
40˚C
NOTE:
For most efficient results the air vent should be closed.
NOTE:
The brushbar will not spin until the machine is reclined.
