3. How to Assemble
IMPORTANT:
Always unplug the vacuum cleaner
from the electrical outlet before assembling or
removing the accessories.
1. Insert the flexible hose into the inlet on the main
body of the vacuum cleaner. Push in until it clicks
into position (Fig.3/1).
2. Push the telescopic extension tube on to the
end of the handle (Fig.3/2).
3. The telescopic extension tube can be
lengthened or shortened by pushing the button in
and sliding the tube apart or together as required
(Fig.3/3).
4. Fit the combination floor head by pushing
onto the extension tube (Fig. 3/4).
4. How to Operate
Cord Release
Fully unwind the power cord. A yellow mark on the
power cord indicates the recommended cord
length. Do not exceed the cord length beyond the
red mark.
On/off Button
1. Insert the power plug into the electrical outlet.
Make sure the vacuum cleaner is switched off.
2. Press the on/off switch located on the top of
the vacuum cleaner, to switch on the vacuum
cleaner and press the button again to turn the
vacuum cleaner off.
Carpet Cleaning
For carpet and rug cleaning, press the rocker
switch on the combination floor head to raise the
brushes.
Hard Floor Cleaning
For hard floor cleaning, press the rocker switch on
the combination floor head to lower the brushes.
Cord Rewind
To rewind the power cord, press the cord rewind
button, located on the top of the vacuum cleaner,
and guide the power cord with one hand. This will
prevent the cord from whipping which could cause
damage or injury.
Variable Power
Located between the on/off and cord rewind
buttons there is a variable power switch. Slide this
forwards and backwards to adjust the suction
power.
Carry Handle
Use the carry handle located at the front of the
vacuum cleaner to move from room to room.
Hose Storage
For convenience, there is a slot located at the back
of the vacuum cleaner where the floor tool and
hose can be parked for carrying and storage.
5. Accessories
1. The accessories can be attached directly to
the handle by removing the telescopic tubes and
pushing in the desired accessory.
2. The accessories can also be attached to the
telescopic extension tube for extra reach. Remove
the combination floor head and push on the
desired accessory.
Crevice tool:
for crevices, corners and cracks, etc.
Dusting brush:
for delicate surfaces.
Upholstery tool:
for carpet, upholstery, stairs, etc.
5
How to Assemble/How to Operate/Accessories
Fig.3/1
Fig.3/2
Fig.3/3
Fig.3/4
V-074_Artwork.qxd 30/3/06 12:50 Page 6
