Always switch OFF the steamer
when fitting the microfibre
cleaning pads.
WARNING
Using your machine
Using your machine
To produce steam squeeze
the trigger in short bursts.
Don’t hold the trigger
continuously to prevent over
wetting carpet.
Move the steamer slowly
backwards and forwards
across the carpet paying
particular attention to high
traffic areas. Squeeze/
release trigger as required.
To release the carpet
glider, place your foot on
clip and push down. Lift
steamer to remove.
Refreshing carpets
Place your foot on floor head
and pull handle backwards
to recline.
IMPORTANT
: Never use the steamer without a cleaning pad attached to the floor head. Never leave the steamer on one spot
for an extended period of time or with a damp or wet microfibre pad attached as this may damage the floor surface.
IMPORTANT:
When using on carpets, always make sure the microfibre cleaning pad is used and covers the floor head entirely
before using the carpet glider
Only use the carpet glider when refreshing carpets and turn the detergent dial to OFF
Place the microfibre pad on
the floor white side facing
up. Place steamer onto pad
making sure the entire pad
covers the floor head.
To steam your floors with
detergent turn the dial to ON
and without detergent turn
the dial to OFF.
Plug into mains and twist
on/off control dial to ON.
The blue light will illuminate
to indicate power on. The
green light will illuminate
to indicate the steamer is
ready to use.
Place your foot onto the
floor head and pull handle
backwards to recline.
Using the steamer
Move the steamer slowly
backwards and forwards
across the floor paying
particular attention to high
traffic areas. Squeeze
/release trigger as required.
To produce steam
squeeze the trigger in
short bursts. Don’t hold
the trigger continuously to
prevent over wetting floors.
Hold corner of pad down with
your foot and lift steamer
to peel away.
Plug into mains and twist on
/off control dial to ON.
Place the microfibre pad on
the floor white side facing
up. Place steamer onto pad
making sure the entire pad
covers the floor head.
With microfibre pad attached,
push steamer into front of
the carpet glider, then place
back of the floor head into the
clip. The carpet glider should
only be used when refreshing
carpets.
Turn the detergent dial to OFF
when refreshing carpets.