Push the steam reach
wand down into
the floorhead until
it clicks into place.
Push the handheld
down onto the steam
reach wand until it clicks
into place.
The steamer is not free standing and must always be
stood either in the wall bracket or safely and securely
against a wall or fixed structure when not in use.
Assembling the steamer
Getting started
Clean & Scrub Kit (Type 1)
1-1-137101
Multi-Surface Kit (Type 1)
1-1-137102
*
To purchase consumables and accessories, please visit
vax.co.uk
Before you Begin
CAUTION:
The steamer and accessories get very hot during use, always allow them to cool down before handling, or changing to
handheld or reach wand mode. Always switch off and unplug the steamer when assembling. Always switch off the steamer before
emptying the twin tank or changing the cloths/accessories.
CAUTION:
This steamer is not free standing, always stand using the wall bracket or securely against a wall/fixed structure,
alternatively lie the steamer flat on the floor in a suitable location so it does not become a trip hazard or can be stepped on.
IMPORTANT:
Please refer to floor/surface manufacturer’s care recommendations before use and test the steamer on a hidden
area to begin with. Test for colour fastness in a small hidden area of upholstery/fabric to check for colour removal before use.
When using the steamer, basic safety precautions should always be observed. Don’t aim the steamer at people, animals, plants,
and electrical components or wires. Never touch the steam jet or floorhead from a short distance (there is a risk of scalding).
The steamer is equipped with a thermostat and a thermal cut-out. If for any reason the steamer overheats it will switch off.
If this happens switch off and unplug the steamer, allow to cool for a least 2 to 4 hours and re-try.
The wall bracket can be fixed against
the wall by either adhesive strips or screw
Fixing the wall bracket
Summary of Contents for S84-W7-P
Page 20: ...Notes ...
