10
Using the hose and tools
IMPORTANT: The machine should be in the upright position when using the hose and tools; this
will de-activate the brushes. To avoid saturating the carpet, do not use more than 4 wet strokes
over any one area. Always end with dry strokes (trigger released).
Push the hose end and hose
solution connector into the
hose connection port.
Open the hose connection
port cover.
Select the SpinScrub or 2-in-1 Antimicrobial tool.
Slide the tool over the tab at the end of the hose until it
clicks into place.
SpinScrub Hand Tool
Suitable for targeting
stains and stubborn marks
on rugs and carpet.
2-in-1 Antimicrobial Tool
Suitable for use on upholstery
and carpeted stairs.
Perfect for reaching
into crevices.
Press the trigger on the
forward stroke to release
water/solution.
Release the trigger on the
backward stroke to pick up
water/solution. For a dryer
finish continue using dry
strokes (trigger released)
until little water is visibly
passing through the tool.
Plug the machine into the
mains and press the
On/Off pedal to switch on.
To remove the hose press
the hose release clip on
the end of the hose and
pull to remove.
Always close the hose
connection port cover
after using the hose. The
machine may lose suction
if it is not closed properly.
Using your machine
