9
Cleaning and maintenence
Cleaning the hose
IMPORTANT: Clean the hose after each use to remove any debris or water left in the hose.
Press the tool lock button
and pull to remove the tool
from the hose.
Empty the dirty water into
the sink or toilet.
Fill a bowl with 500ml of
warm water (no solution).
Plug the machine into the
mains and switch on.
Submerge the end of
the hose into the bowl of
water. Do not squeeze
the trigger.
Once the bowl is empty,
let the machine run for
10 seconds to remove
residual water and dirt left
in the hose. Repeat the
process again if needed.
Press the on/off button to
switch the machine on.
Press the on/off button to
switch the machine off.
Unplug the machine from
the mains.
Pull and Lift the lid to
remove from the dirty
water tank.
Empty the dirty water into
the sink or toilet.
Press the dirty water tank
release button. Pull to
release the tank and lift by
the carry handle to remove.
10
Push the tab up and over
the latch to remove the
SpinScrub tool from the
hose.
