Changing the belt
Switch off your vacuum
cleaner at the main socket
and unplug. Unclip the 2
small wheels from the base
of the vacuum to enable you
to remove the screws from
behind. Note: The screw for
the height adjuster dial is
located here.
Remove the 9 screws
from the base of the
floorhead cover.
Remove the floorhead cover.
Lift the brushbar from the
machine to remove the belt.
Note: To remove debris
from the brushbar see
‘Lets talk technical’ on the
previous page.
Place the brushbar through
the belt and hook the belt
onto the metal spindle.
Once the belt has been
replaced attach the
brushbar back onto the
vacuum.
Replace the floorhead
cover, 2 small wheels and
height adjuster dial by
screwing back into place.
What to do if it goes wrong
• Check the ‘This pack contains’ panel on the box to make sure the part
is included with your machine.
• There may be a blockage in the hose. Please remove the hose from the
vacuum cleaner, check and clear any blockages.
• Empty the dirt container and clean filters.
Go to the ‘Taking care of your machine’.
• The brushbar may not be turning. Go to my brushbar isn’t turning below.
• If the accessory/tool will not pick up, check and clear any blockages.
• The plug may not be fully pushed into the electrical socket.
• Check the fuse in the plug if this needs replacing, always replace with
a British 13amp fuse.
• The motor thermostat may have tripped. If this has happened, unplug
the vacuum cleaner. Remove and empty the dirt container and check
the hose for blockages.
• Clean the filters and allow the vacuum cleaner to cool for
approximately 1 hour (if you have washed the filters you will need to
wait 24 hours for the filters to fully dry before putting them back into
the vacuum cleaner).
• The brushbar may be clogged, check the brushbar and clear any hair
or debris. Go to ‘Let’s talk technical’.
• The belt may be broken. Go to ‘Let’s talk technical’.
Solution
Problem
IMPORTANT:
To reduce the risk of personal injury, unplug the vacuum before performing maintenance
/troubleshooting checks.
There is an
accessory missing
Why does my
vacuum cleaner
have no power?
Why won’t the vacuum
cleaner pick up?
My brushbar
isn’t turning?
Let’s talk technical
Removing blockages from the TurboTool
Push both buttons to open the TurboTool.
Using a pair of scissors, cut
any hair or debris free from
around the brushes.
Remove the rubber ring.
If the air inlet, hose or telescopic
tube is blocked, switch off the
vacuum cleaner and remove the
blockage(s) before re-starting the
vacuum cleaner.
CAUTION
U85-E2-BePeRe_EnergisePulse_UG_100914_PRINT.indd 12-13
12/09/2014 14:24
