Vax Service line:
AU: 1300 361 505
NZ: 0800 800 900
vax.com.au
10
Operation
Usage
1. Plug in machine to power supply.
2. Press the red button to turn on the power.
3. Press the green button to activate the pump.
2. With the solution flowing, wash a section of carpet approx. 3 metres x 3 metres by pushing the wash head
backwards and forwards over the area.
4. To wash the next section of carpet, repeat steps 1 to 3. Continue until the area is washed.
5. When clean water reservoir is empty, solution will stop flowing through the wash head and the pump will
make a ‘sound’ due to sucking air. Refill the water reservoir with clean water and Vax Carpet Cleaner.
Be sure to empty the dirty water recovery bucket at this time.
6. If the dirty water recovery bucket becomes full, the ‘sound’ your Vax makes will change and suction will drop.
Time to empty it! Failure to do so will activate the float which, with continued use, will cause the machine
to overheat.
Washing Carpets
1. On the Fibreflow wash head
ensure that the rocker switch (A)
is towards the back of the head
to allow water to flow through
the head.
3. Stop the solution flow by moving
the rocker switch (A) to the
forward position on the Fibreflow
wash head. This will prevent
water flow, allowing excess
water to be removed from the
section just washed.
