Vauni Globe, Manual

Page: 25 / 56

© Copyright 2020 Vauni AB - All rights reserved Vauni Globe
| 25
ENG
ENG
help you find the right way. Reinstall the four screws and washers. Make sure that the rubber on the tiles are
pressed against the bottom plate and tighten. Go to point 5 or continue below:
Installation of granite liner: (this can in some cases already been mounted)
If necessary, take out the burner. Dismount the metal insert by loosening the three wing nuts. Remove the
spacers by screwing them off. Then lift out the metal insert and lif in the granite insert. Make sure that the
three recessed holes is above the corresponding holes in the holder. Install the supplied three sunk screws,
washer and wing nut. Adjust the position so that the granite insert has an even gap all around. Tighten the
screws. Go to point 5.
5. Lower the burner in the provided holder into the hearth. Ensure that the burner sits straight and that its
front part is placed in the direction toward the hearth’s opening (Figur 4).
6. Place the regulator lid by lowering the two guide pins into the respective grooves (Figure 5A). When
correctly placed, the regulator lid should lie closely against the burner’s surface and slide easily when the
regulator rod (which grips in the holes provided in the regulator lid) moves it to its respective stop. In the
open position, the regulator lid should be entirely in front of the burner’s opening as seen from in front of
the hearth (Figures 5B, 6).
Now that the hearth is completely assembled, read Section 4 Firing for instructions on how to start it the
first time.
FRONT
4 5
A
B
6
2
3