5
Surface Mounting Options
Semi-Permanent
For a semi-permanent mounting solution, use the (4) duraco strips (j) included with
your base. Use a phillips head screwdriver to remove the 4 rubber feet on the bot-
tom of the base. Peel off one side of the film and stick it to the four positions pic-
tured above. Let the adhesive
cure onto the base for 3 hours before peeling off
the other side and sticking it to your desired surface. Once you have stuck the base
down to a surface, let it sit for another
12 hours with NO interaction before use. To
remove duraco, take a piece of filament such as fishing line or dental floss and run
underneath the base in a sawing motion to cut the adhesive
For a non-permanent mounting solution, use the (4)
included black rubber feet (i). These feet come pre
installed on your kiosk base. Set your kiosk up wher-
ever you like for a non-permanent mounting solution
Standard
Permanent
The most secure way to mount your kiosk to the floor is using the included lag bolts to anchor the
base in the floor. This process will make permanent holes in your floor and requires power tools and
more advanced knowledge.
➁
Drill 3 holes
14mm(.55 inches)
wide and 72mm(2.83
inches) deep*
72mm(2.83 inches)
14mm(.55 inches)
➂
Hammer the Lag
assembly into the
hole with a hammer
➃
Unscrew the phillips
head bolt and place
your base over the top
of the 3 holes in the
floor. Hand tighten the
bolts back down until
the base is tight.
➄
Insert plugs
➀
Use the included
hole diagram to mark
where the 3 lag bolts
will be drilled into the
floor
* VAULT does not take any liability for damage to your building by installing the anchors.
