4
BATTERY SYMBOL STATUS
“Battery Full”
“Battery Low”: Batteries MAY be replaced .
“Battery Empty”: Batteries MUST be replaced .
BATTERY INSTALLATION/REPLACEMENT
To install or replace the batteries:
1 . In the back of the meter, gently slide the battery housing cover away .
2 . Remove old batteries and insert two new AAA batteries according to the
battery direction markings inside the battery housing .
3 . Reinstall battery housing cover .
4 . Properly dispose of old batteries in accordance with local regulations .
OPERATING INSTRUCTIONS
Never aim the laser beam pointer at the eyes of a person or animal or
an object other than the work piece.
Pre-measurement setting:
1 . To turn on the meter and laser pointer, briefly press the red button .
2 . To set for desirable measurement units (inch, foot, metre), while
pressing on the red button, toggle between the measurement units
using the black button .
3 . To toggle between front or rear edge measurements, briefly press
black button .
Measurement:
1 . For single measurement:
a . Direct the laser at the target and briefly press the red button .
The distance to the target appears on the display .
b . For additional single measurements, press the red button to
clear the display and to turn on the laser pointer . Repeat step 1a .
2 . For continuous measurement:
a . Direct the laser at the target and press the red button for 2
seconds until a clicking noise is heard . As you move toward
or away from the target, the distance to the target appears on
the display .
b . For additional measurements, press the red button to clear
the display and to turn on the laser pointer . Repeat step 2a .
Post-measurement:
• To convert the measured distance to other units of measurement, briefly press both red and black buttons at
the same time .
• To turn off the meter, press the black button for 2 seconds .
Front Edge Measurement
Rear Edge Measurement
Continuous Measurement
Distance
Distance
