Vassilias Stiroplus SP1110, Manual

Page: 10 / 12

Page 10 of 12
USING YOUR STEAM STATION
Steam Ironing
The machine works with normal tap water. In case of very hard water (hardness above 27ºF) we
suggest using 50% distilled water diluted with tap water. Alternatively, we suggest using normal
bottled drinking water. The use of de-ionized water is not recommended.
1) Place the device on a stable and heat-resistant surface
2) Twist off the tank
3) Fill the tank with water. The water tank capacity is 1.5 liters.
4) Adjust the temperature dial in terms of choose the kind of fabrics that you want to iron.
Note: If you want to use the steam ironing, we suggest you to adjust the temperature dial on
MAX.
5) Insert the plug in the wall outlet and turn on switch. Τ he soleplate starts heating
up, and the temperature indicator light shows breathing light.
6) When the iron operating light indicator goes on, the iron will be ready for use
Note: During the whole operating time, the iron operating light indicator will go on and off in
erratic intervals, this is normal.
7) To make the steam jet come out, press the steam trigger.
If the steam stops coming out, this is probably because there is no more water in the tank. In
order to continue ironing, fill in with water.
Burst of steam
Press the steam trigger twice to activate the burst of steam function and then you can use the
shot of steam to remove the tough wrinkle.
Dry Ironing (without steam)
a) Place the device on a stable and heat-resistant surface
b) Adjust the temperature dial in terms of the kind of fabrics that you want to iron.
c) Press the power switch, the soleplate start heating
up, and the temperature indicator light shows breathing light.
CLEANING AND MAINTENANCE
After unplugging the device from the wall outlet, let it completely cool down and then clean it
with a damp cloth. Don’t use any detergents, but only a soft cloth dampened with lukewarm
water. Replace the iron vertically in a dry and clean place.
Note: Possible servicing operations for damage or fault caused by the formation of scale are not
covered by the guarantee.
Cleaning mode
The machine has intelligent reminder cleaning mode and active cleaning mode respectively.
Smart reminder cleaning mode reminds the user to clean the device.
When cleaning light is on it reminds users to clean the machine. To start cleaning push the
cleaning button for 3 seconds until it start flashing.
Then press the trigger. The machine will enter into cleaning mode and start from the soleplate
hole steam discharge sewage. The cleaning time will last for 1 minute, and the cleaning mode
will end when the cleaning light is off. If you need to exit the cleaning mode, please press the
cleaning button for 3 seconds until the light is off.
ATTENTION: This device must be repaired only by qualified technicians authorized by specific
centers.