Note:
There may be noise when pumping the water for the first time, it is normal, as the
appliance is releasing the air in the appliance. After about 20s, the noise will disappear.
PREHEATING
To make a cup of good hot Espresso coffee, it is recommended to preheat the appliance
before making coffee, including the funnel and cup, so that the coffee flavour will not be
influenced by the cold parts.
1. Remove the removable water tank and fill it with desired water, the water level should be
between the “MAX” mark and the “MIN” mark in the tank. Then insert the tank into the
appliance properly.
2. Set steel mesh into metal funnel (no coffee in steel mesh), then put the metal funnel under
the metal funnel holder (see Fig.1), and turn it anticlockwise until it is fixed tightly (see Fig.2
and Fig.3).
3. Place an espresso cup you have prepared on removable cup shelf.
4. Then connect the appliance into power supply. Make sure the steam knob is at the "O"
position.
5. Press the ON/OFF button
“
” to turn on the unit, the power indicator (red) will illuminate,
make sure the coffee/steam button
“
”
/
“ ”
is at the higher position.
6. Press down the pump control button
“
”
to the lower position, when there is water
flowing out, close the pump immediately by pressing the pump control button
“
”
again to
the higher position. The purpose of the step is to pump the water of the tank into the housing.
7. When the coffee indicator (green) is illuminated, and you should press down the pump
