Varytec SuperClam RGB, Manual

Page: 4 / 13

IMPORTANT:
Damages caused by the disregard of this user manual are not subject to warranty. The dealer will not
accept liability for any resulting defects or problems. Make
by qualified personnel. All electrical and mechanical connections have to be carried out according to
the European safety standards.
1.2. Further safety instructions
IMPORTANT!
Handle with the dangerous electric
With this voltage there is the danger to get a life
After taken the device from a cold room to a warm room, it is not allowed to activate the device. It is
possible that thereby emerged condensed water damag
it reached ambient temperature.
Make sure that the voltage which it is connected to does not exceed the specified values.
Don’t switch the device in short time intervals (e.g. in second cycle) on or off.
Keep away children and laymen off the device.
Health risk!
Don’t look directly into the light source. At certain circumstances it is
possible that some people get epileptic seizures. This is especially true for
individuals whose epilepsy was determined by
1.3. Designated use
This device was developed for professional use on stages, in discos, theatres etc. The device is only
approved for a connection up to 230V 50/60 Hz AC voltage.
Regular breaks during operation increase the lifetime of your device.
Avoid vibrations or any form of forceful impact during the installation, the start
device.
Make sure that the device is not exposed excessive heat, humidity or dust at the place of installation.
Take care that no cables are lying a
a third party.
It is not allowed to operate or store the device in an environment in which spray water, rain, humidity
or fog is expected. Humidity or very high atmospheric humidity could red
and could cause deathly electric shocks. If you use fog devices the device may not be exposed to a
direct smoke jet. There has to be a safety distance of at least 0.5m between this device and the fog
machine. Make sure that the saturation of the fog has to enable a visibility of at least 10m.
Do not operate the device during thunderstorms. Surge voltages could destroy the device. Unplug the
device from the power supply during thunderstorms.
For installation the use of the mo
Surrounding objects or surfaces should not be in contact with the device.
Make sure that during the installation and removal of the device the area below the place of
installation is basically cordoned off. This also applies
4 / 13
Damages caused by the disregard of this user manual are not subject to warranty. The dealer will not
accept liability for any resulting defects or problems. Make sure the electrical connection is carried out
by qualified personnel. All electrical and mechanical connections have to be carried out according to
Further safety instructions
IMPORTANT!
Handle with the dangerous electric voltages carefully.
With this voltage there is the danger to get a life-threatening electric shock.
After taken the device from a cold room to a warm room, it is not allowed to activate the device. It is
possible that thereby emerged condensed water damages the device. Do not activate the device until
Make sure that the voltage which it is connected to does not exceed the specified values.
Don’t switch the device in short time intervals (e.g. in second cycle) on or off.
ep away children and laymen off the device.
Don’t look directly into the light source. At certain circumstances it is
possible that some people get epileptic seizures. This is especially true for
individuals whose epilepsy was determined by a doctor.
This device was developed for professional use on stages, in discos, theatres etc. The device is only
approved for a connection up to 230V 50/60 Hz AC voltage.
Regular breaks during operation increase the lifetime of your device.
Avoid vibrations or any form of forceful impact during the installation, the start-up or Operation of the
Make sure that the device is not exposed excessive heat, humidity or dust at the place of installation.
Take care that no cables are lying around. You would endanger your own safety and also the safety of
It is not allowed to operate or store the device in an environment in which spray water, rain, humidity
or fog is expected. Humidity or very high atmospheric humidity could reduce the isolation of the device
and could cause deathly electric shocks. If you use fog devices the device may not be exposed to a
direct smoke jet. There has to be a safety distance of at least 0.5m between this device and the fog
the saturation of the fog has to enable a visibility of at least 10m.
Do not operate the device during thunderstorms. Surge voltages could destroy the device. Unplug the
device from the power supply during thunderstorms.
For installation the use of the mounting bracket is obligatory.
Surrounding objects or surfaces should not be in contact with the device.
Make sure that during the installation and removal of the device the area below the place of
installation is basically cordoned off. This also applies to implementation of service.
Damages caused by the disregard of this user manual are not subject to warranty. The dealer will not
sure the electrical connection is carried out
by qualified personnel. All electrical and mechanical connections have to be carried out according to
threatening electric shock.
After taken the device from a cold room to a warm room, it is not allowed to activate the device. It is
es the device. Do not activate the device until
Make sure that the voltage which it is connected to does not exceed the specified values.
Don’t look directly into the light source. At certain circumstances it is
possible that some people get epileptic seizures. This is especially true for
This device was developed for professional use on stages, in discos, theatres etc. The device is only
up or Operation of the
Make sure that the device is not exposed excessive heat, humidity or dust at the place of installation.
round. You would endanger your own safety and also the safety of
It is not allowed to operate or store the device in an environment in which spray water, rain, humidity
uce the isolation of the device
and could cause deathly electric shocks. If you use fog devices the device may not be exposed to a
direct smoke jet. There has to be a safety distance of at least 0.5m between this device and the fog
the saturation of the fog has to enable a visibility of at least 10m.
Do not operate the device during thunderstorms. Surge voltages could destroy the device. Unplug the
Make sure that during the installation and removal of the device the area below the place of
to implementation of service.